Simple schematic for building serial interface :

On 9-pin Serial plug :
Ground : Pin 5
Data : Pin 1 (actually DCD)

Existing Hauppauge interface :

2.5mm Connector
TSOP 2238 IR Receiver
Ring Signal
Shield Ground

VSOP (or Everlight) IRM2238
VCC=5V, 38KHz

USB Pinout :
Pin 1 : VCC (+5V)
Pin 2 : Data-
Pin 3 : Data+
Pin 4 : Ground

Even simpler circuit for IR receiver used the +5V power from USB bus. This does away with the need for the regulator and the capacitor. Only component required (in addition to the Hauppauge IR receiver) is a 3K3 Ohm resistor wired as a data pull-up to the +5V VCC from the USB. Connect the grounds of USB, Serial port and IR receiver together.

Since I only wanted the receiver for long enough to record a few remote controls, no elegant solution was needed. Indeed, the rats’ nest of wires is too embarrassing to even show to anyone.

[root@americas yoshika]# /sbin/rmmod lirc_serial
[root@americas yoshika]# joe /etc/modprobe.conf

alias char-major-61 lirc_serial

For COM1 :

install lirc_serial /bin/setserial /dev/ttyS0 uart none ; /sbin/modprobe –ignore-install lirc_serial
options lirc_serial irq=4 io=0x3f8

Or for COM2 :

#install lirc_serial /bin/setserial /dev/ttyS1 uart none ; /sbin/modprobe –ignore-install lirc_serial
#options lirc_serial irq=3 io=0x2f8

[root@americas recorded]# irrecord Marantz_RC4300CC

[root@americas recorded]# mode2
pulse 29
space 1892519
pulse 2843
space 999
pulse 915
space 2897

[root@americas recorded]# cp viewmaxpro /etc/lircd.conf

[root@americas recorded]# /etc/init.d/lircd restart
Stopping infrared remote control daemon: [ OK ]
Starting infrared remote control daemon: [ OK ]
[root@americas recorded]# irsend LIST “” “”
irsend: viewmaxpro
[root@americas recorded]# irsend SEND_ONCE viewmaxpro Mute
[root@americas recorded]# irsend SEND_ONCE viewmaxpro Mute
[root@americas recorded]# irsend SEND_ONCE viewmaxpro Mute

Test that something is being sent using a digital camera (which should see flashes from both remote control LEDs and the IR blaster.

[root@americas recorded]# irsend SEND_ONCE viewmaxpro 5;sleep .2;irsend SEND_ONCE viewmaxpro 6;sleep .2

Martin Andrews

{Finance, Software, AI} entrepreneur, living in Singapore with my family.